递进式集中油脂润滑系统

递进式油脂润滑系统由油脂滤油器、抵抗式油脂润滑泵(或递进式油脂润滑泵 )、递进式分配器 、铜接头 、油管等组成 。

1、系统特点

·系统强制向每个润滑点注油。

·给油量精准，出油量固定，不因油品黏度、温度变化而变化。

·循环检测开关可监测润滑系统管路断流、失压、堵塞、卡死等状况。

·系统中任何一个分配器出油孔出现不作动时，系统循环供油将会产生异常。

2、系统配置注意

·主油管须用铜管或高压橡胶油管。

·为确保每次循环每个润滑点出油，一个出油口只能对应一个润滑点。

3、安装使用注意

·各连接油管口裁剪平整，确实连接完好不漏油。

·安装时保证各管路内部清洁。

·请使用正厂乾净无杂质的0O〇#—O#油脂。

·适用温度0~50℃。

·请从正确的加油孔加油，严禁打开抑油块从油杯上方加油。注意使用环境温度变化，适当调整使用油品黏度，建议在15℃以下时用0O0#，25℃以上时用000#一0#。

4、基本适用范围

广泛适用于润滑点群多，管路距离远(高)，给油量精准与每点必须强制给油的机械设备。

5、系统搭配递进式分配器

GPA、GSA、GPB递进式黄油分配器。

6、该系统主机包括

柱塞泵类:GEE、GEC-o1、GEB-01、GEA-01

齿轮泵类:GTA-A、GTA-C

System features

·The system forces oil injection to each lubricating point.

·The oil is supplied accurately and ejected oil quantity is constant ,which is not changed subject to oil viscosity and temperature.

·The cycle testing switch can monitor the lubricating system out of flow, out of pressure , blocking and sticking etc.

·when oil outlet of any distributor of the system does not work , cycle oil supply of the system may be fault.

Attentions for system configurations

· The main oil pipe shall be made of copper pipe or high-pressure rubber oil pipe.

·To ensure that oil is ejected to each lubricating point each point , each oil outlet is corresponding to one lubricating point.

Attentions for installation and use

·The oil outlet pipeline orifices shall be cut in order, and connection is perfect without oil leakage.

·ln the process of installing，please ensure that interior of the pipeline is clean.

·Please use the correct，clean and impurity-free 00O#-O# oil grease.

·Applicabie temperature 0~50℃.

·Please refill oil from the correct oil refilling orifice. Do not open the oil block to refill oil above the oil cup.

·Please notice temperature of environmental temperature，adjust viscosity of oil products, 000"oil grease is recommended under the temperature of below 15℃ ,and 000#―0# oil greases are recommended for temperature above 25℃.

Basic scope of application

Extensively used for machinery and equipment with excessive lubricating points, distance pipelines, and accurate oil supply point for compulsory oil supply.

Ystems with progressive distributor

The system is configured with progressive distributor. GPA , GSA , GPB progressive butter distributor.

The system is composed of

Plunger pump: GEE、GEC-01、GEB-01、GEA-01 Gear pump: GTA-A，GTA-C

GSA型 油脂比例接头